Question Adding Lati - Longi to a Media file. Is it possible??

Not sure if this is the right forum to ask this question.. However!!

I understand that Lati & Longi can be added to a PLACE, which in theory is where the media (photo) is from. I am thinking of Gravestone pictures within a cemetery and the like..

Is there any way this could be achieved??

Thanks in advance!!

GEDCOM 5.5.1 and 7.0 don‘t support the information when and where a photo was taken. You can add that as a OBJE:NOTE only. And you can add the LAT/LON at the burial event. 

Using jpg you can have these infos within the exif tags.

Thanks Hermann & Franz,

Neither of these came to me until you pointed them out..

 

hermann wrote:

GEDCOM 5.5.1 and 7.0 don‘t support the information when and where a photo was taken. You can add that as a OBJE:NOTE only. And you can add the LAT/LON at the burial event. 
 

Hi Hermann

I was away from Internet for a while then had a bad bout of flu, hence my late follow-up..

I cannot see where to add Lat/Lon at the burial event.. Have tries looking it up on Internet with not much luck..
Would you provide a sample Burial Event with Lat /Lon included please?

Cheers

I think Lat/Long are subtags of PLAC, so anywhere you can use a place you also can specify exact coordinates.

So just put a place to the burial, and you can extend that with the coordinates.